Lit. No. 94432, Rev. 05
4
March 1, 2009
SWING AWAY
®
MOUNT INSTALLATION INSTRUCTIONS
SWING AWAY Mount Installation
1. Remove all mount assembly parts and hardware
from the shipping carton.
2. Install both top swivel supports to the top brackets
with one 1/2" x 1-3/4" cap screw, one 1/2"
fl
at
washer and one 1/2" locknut per side. Tighten
snug but do not fully torque hardware at this time.
3. Set the driver side base plate on the bumper in the
approximate area that it will be installed.
4. Set the driver side top bracket assembly on the
truck bed rail and clamp in place.
5. Drop the hinge pin into place through the top
swivel support and into the base plate. Adjust the
base plate and top bracket assembly to provide at
least one inch of clearance between the hinge pins
and any point of the truck. The pin must also be
positioned vertically.
1/2" Locknut
1/2" Flat Washer
1/2" x 1-3/4"
Cap Screw
Top Swivel Support
1/2" x 1-3/4" Cap Screw
1/2" x 1-3/4"
Cap Screw
1/2" x 1-3/4"
Cap Screw
Hinge Pin
Hinge Pin
Base Plate
Base Plate
Top Bracket
Top Bracket
Hairpin Cotter
Connector
Channel
Connector
Channel
End Channel
Assembly
Top Swivel Support
3/8" x 1-3/4"
Cap Screw
3/8" x 1"
Cap Screw
5/16" x 1-1/4"
Cap Screw
1/4" x 1-3/4"
Cap Screw
Top Swivel Support
