Spring Driven Hose Reels
Spring Driven Hose Reels
Page 3
Item
#
Description
#
Req.
Item
#
Description
#
Req.
75396
75397
1
Swivel Assembly
1
3
90° Ell
1
4
Sheave Assembly
1
5
Drive Spring Assembly
1
6
Spring Arbor Assembly
1
7
Gasket
1
8
Spring Case Assembly
1
9
10-32 Hex Locknut
6
10
Main Shaft
1
11
1 1/4” Snap Ring
2
12
Base Assembly
1
13
1/2-13 Set Screw
1
14
Guide arm with Rollers
1
15
Bumper Stop Assembly
1
16
5/16-18 Locknut
4
17
10-32 x 3/8” Nyloc Nut
1
18
1/2-20 x 5/8” Hex Nut
1
19
Latch Spring
1
21
10-32 Shoulder Screw
1
22
Latch Pawl Assembly
1
23
3/8-24 Jam Nut
1
24
Spring Case Stud
1
25
U-bolt
1
26
1/4-20 X 3/8” Locknut
4
28
Swivel Union
1
Hose Assembly
Reel Model
33340
33359
Hose I.D. x Length
1/2” X 35’ 1/2” X 50’
Reel Inlet Connection
1/2” FPT
1/2” FPT
Max. Operating Pressure
200 PSI
200 PSI
Max. Operating Temperature
160 °F
160 °F
Item
# Req.
# Part
Description
29
1
33413
Hose RRA 1/2 X 24
30
31
32
1
32840
Spray Gun
1
33340 / 33359
Hose Assy 1/2” X 35’ or 1/2” X 50
’
1
3298
PST Thread Sealant
1. Connect the lead-in line (29) to the reel (75396 / 75397) inlet located on the right-hand side of the hose reel,
by applying PST (32) or plumbers tape on the male 1/2” NPT threads on the lead-in line (29) and thread it
to the reel (75396 / 75397) using a wrench to support the swivel while tightening the lead-in line.
2. Connect the 1/2” female end of the lead-in line (29) to the water supply using PST (32) or plumbers tape
and tighten.
3. Turn on water supply and flush the reel line to remove any debris from the reel for a few seconds and
then turn off water supply.
4. Attach the spray gun (30) to the reel hose (31). By applying PST (32) or plumbers tape on the 1/2” NPT male threads on reel hose
and tighten.
5. Turn water supply on and check for leaks.
NOTE:
Apply PST or Plumber Tape on
the following locations to prevent any
leaks.
1
1
1
29
31
30
32
