4
Assembly
• Fit the ends of the seat back tube into the seat back hubs.
• Push the seat back tube into the hubs until you hear a
"click"
on
each side.
• Pull up on the seat back tube to be sure it is secure.
Hint:
The seat back tube is designed to only fit one way. If it comes
out of the seat when you pull on it, turn it around and try again.
Seat Back Tube
Seat Back Hubs
6
• Turn the seat face down.
• Fit the frame tube connector to the pegs on the seat bottom.
• Insert four #8 x 1,9 cm screws into the frame tube connector and
tighten with a Phillips screwdriver.
Frame Tube
BOTTOM VIEW
7
• Insert the M5 x 40 mm bolt through the hole in the the upper seat
tube.
Fully tighten the screw with the Allen wrench.
• Turn the assembly upright.
9
• Turn the frame assembly on its side.
• Slide the frame tube into the motor assembly tube.
8
Motor Assembly Tube
Frame Tube
10
Pad
• Fit the upper pocket on the back of the pad over the seat back tube.
