background image

2

2

• Please keep this instruction sheet for future reference, as it 

contains important information.

• Adult assembly is required.
• Tools needed for assembly: Phillips screwdriver and hammer 

(tools not included).

• Requires three, “AAA” (LR03) 

alkaline

 batteries for sounds and 

lights box operation (not included).

• For children ages 1 

1

/

2

 - 5 years.

• Weight limit: 55 lbs (25kg).
• This product is intended for use on smooth, paved surfaces, 

away from motor vehicles.

Care

• Periodically check plastic parts and if broken or cracked, 

dispose of them properly. Periodically check all fasteners 
regularly to be sure they are tight. If the fasteners are not 
tight, tighten them as necessary.

• To clean, use a mild soap and water solution and a clean 

cloth. Rinse clean with water to remove soap residue.

Consumer Information

Consumer Information

This product contains small parts 

in its unassembled state. 

Adult assembly is required.

   CAUTION

To avoid serious injury:

•  Adult supervision required.
•  Never use near cars and other motor

vehicles, near streets, steps, 
slopeddriveways, hills, roadways, alleys, 
swimming pools or other bodies of water.

•  Always wear shoes.
•  Never allow more than one rider.

   WARNING

FCC Statement (United States Only)

This equipment has been tested and found to comply with 
the limits  for a Class B digital device, pursuant to Part 
15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and 
can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is 
no guarantee that interference will not occur in a particular 
installation. If this equipment does cause harmful interference 
to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the
following measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment

and receiver.

•  Consult the dealer or an experienced radio/TV technician

for help.

Note: Changes or modifications not expressly approved by the 
manufacturer responsible for compliance could void the user's 
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is 
subject to the following two conditions: (1) this device may not 
cause harmful interference and (2) this device must accept any 
interference received, including interference that may cause 
undesired operation.

ICES-003

• This Class B digital apparatus complies with Canadian

ICES-003.

• Operation is subject to the following two conditions: (1) this 

device may not cause harmful interference and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.

NMB-003

• Cet appareil numérique de la classe B est conforme à la 

norme NMB-003 du Canada.

• L’utilisation de ce dispositif est autorisée seulement aux 

conditions suivantes: (1) il ne doit pas produire de brouillage 
et (2) l’utilisateur du dispositif doit être prêt à accepter tout 
brouillage radioélectrique reçu, même si ce brouillage est 
susceptible de compromettre le fonctionnement du dispositif.

Содержание T4444













Отзывы: