4
Assembly
Handle Tubes
Back Base
• While pressing the buttons on the ends of the back base, insert
the ends into the tube ends in the handle.
Make sure the back
base “snaps” into place.
• Pull the back base to be sure it is secure to the handle tubes.
• Turn the assembly upright.
• Position the soothing unit upright and fit the groove to the
front base, as shown.
• Insert two 4 mm x 30 mm screws through the front base and
into the soothing unit. Tighten the screws.
Soothing Unit Groove
Front Base
3
4
Front Base
Lower Pocket
• Fit the pad lower pocket around the front base and soothing unit.
• Turn the assembly face down.
• Fasten both pad side flaps to the strap on the back of the pad.
Make sure you hear a
“snap”
on both sides.
Seat Back Tube
Upper Flap
• Fit the upper flap on the pad around the seat back tube.
5
6
PRESS
PRESS
