Assembly
3
• Position the elevator shaft on a flat surface.Note the
locations of the bottom slots, snap slot and retainer on
the elevator shaft.
• While holding the base at an angle, fit the locator tabs
into the bottom slots in the elevator shaft
A
.
• While making sure the base lip fits over the elevator
shaft ledge
B
, insert and snap the hooked tab on the
base into the slot in the elevator shaft
C
.
• Insert and snap the tab on the side of the base ramp
into the retainer in the elevator shaft
D.
• Insert and snap all five top floor columns into the
grooves in the base. Make sure the top floor lip fits
over the elevator shaft ledge.
1
2
A
A
B
C
B
C
D
Elevator Shaft Ledge
Base
Lip
Base
Tabs
Retainer
Bottom Slots
Elevator Shaft
Elevator
Shaft
Ledge
Top Floor Lip
Base
Groove
Grooves
Top
Floor
Columns
Groove
D