Lit. No. 74916, Rev. 01
5
July 15, 2020
95150, 95160, 95180-3, 95190-3
TORQUE CHART
1/4-20
109
154
1/4-28
121
171
5/16-18
150
212
5/16-24
170
240
3/8-16
269
376
3/8-24
297
420
7/16-14
429
606
7/16-20
9/16-12
9/16-18
5/8-11
5/8-18
3/4-10
3/4-16
7/8-9
7/8-14
474
669
644
909
1-8
1-12
704
995
1/2-13
1/2-20
11.9
13.7
24.6
27.3
43.6
26.9
53.3
93
148
49.4
69.8
77.9
106.4
120.0
8.4
9.7
17.4
19.2
30.8
35.0
49.4
55.2
75.3
85.0
M6 x 1.00
M12 x 1.75
M8 x 1.25
M14 x 2.00
M10 x 1.50
M27 x 3.00
M22 x 2.50
M30 x 3.50
M24 x 3.00
M20 x 2.50
11.1
19.5
38.5
67
107
7.7
613
778
1139
1545
450
428
562
796
1117
M33 x 3.50
M36 x 4.00
2101
2701
1468
1952
325
M16 x 2.00
231
167
M18 x 2.50
318
222
Recommended Fastener Torque Chart
Size
Size
Torque (ft-lb)
Grade
5
Grade
8
Metric Fasteners Class 8.8 and 10.9
These torque values apply to fasteners
except those noted in the instructions.
Torque (ft-lb)
Grade
5
Grade
8
Size
Size
Torque (ft-lb)
Class
8.8
Class
10.9
Torque (ft-lb)
Class
8.8
Class
10.9
Inch Fasteners Grade 5 and Grade 8
CAUTION
Read instructions before assembling.
Fasteners should be finger tight until
instructed to tighten according to the torque
chart. Use standard methods and practices
when attaching snowplow, including proper
personal protective safety equipment.
HEADGEAR TO T-FRAME ASSEMBLY
NOTE: For easier assembly and installation, the
vehicle and all snowplow components should
be on a smooth, level, hard surface, such as
concrete.
1.
With the vehicle parked on a solid, level surface,
measure the distance from the center of the
connecting pin hole to the ground. Refer to the
table below to determine which T‑frame hole
should be used to attach the headgear to the push
assembly. If the vehicle is unavailable, use hole 2
and reposition the headgear later if necessary.
Pushplate Height
(hole center to ground)
T-Frame
Hole
14.25" to 15.5"
1
13.0" to 14.25" (typical)
2
11.75" to 13.0"
3
2.
Set aside the pivot pin, parts bags, and blade
guides.
Measure
this distance.
Center of
Connecting
Pin Hole
Hole 1
Hole 2
Hole 3
