Lit. No. 74916, Rev. 01
11
July 15, 2020
95150, 95160, 95180-3, 95190-3
2.
Remove and retain the U‑bolt and locknuts that
secure the lift chain on the passenger's side of the
T‑frame. Reposition the U‑bolt in the chain so that
the chain is the same length as the chain on the
driver's side.
3.
Reinstall the U‑bolt in the T‑frame and tighten the
locknuts. The chain link should pivot freely in the
U‑bolt.
4.
Raise and lower the snowplow in the fully
retracted (vee) position to verify that the hydraulic
hoses bow outward and do not interfere with
snowplow components.
NOTE: Ensure that the base-end angle ram hoses
are wrapped over the diagonal brace. Adjust
hoses, fittings, and wraps as necessary to prevent
any hoses from being pinched.
FINAL ADJUSTMENTS
Lift Chain
1.
Adjust the length of the lift chain on the
driver's side (with attached spring) so that the
T‑frame hits the T‑frame stop when the lift ram is
fully extended (10").
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between the vehicle and blade or directly in
front of the blade. If the blade hits or drops on
you, you could be seriously injured.
10"
T-Frame
Stop
