2004 Wheaton Science Products
20
P/N 50083244
Specifications subject to change without prior notice
•
Press the
∗
key until the CYCLE RPM light turns on.
•
Use the UP and DOWN arrow keys to set the INITIAL running speed of the
unit (A).
•
Press RUN / STOP to start the unit running in two speed stirring mode. The
RUN light will BLINK until the unit reaches full set speed.
•
While the unit is running during the initial stirring time (B), the CYCLE RPM
and CYCLE TIME ON time lights will alternately blink to show remaining initial
stirring time, and initial stirring speed (A).
•
Once the initial stirring time (B) expires, the unit will revert to the final running
speed (C).
6.6
Combination Cycle and Two Speed Stirring
The Biostir
®
can be set to run in a combination cycle and two speed stirring
mode, where an advanced stirring profile is needed for demanding applications.
Below, is a typical combination cycle and two speed stirring profiles, showing a
running cycle pattern at an initial stirring speed (A), and then the unit ramping to
a final programmed constant speed (D). The upper profile shows the unit
ramping to a higher speed, while the lower profile shows the unit ramping to a
slower speed.
