44
BEFORE YOU CALL FOR SERVICE
PROBLEM
DISPLAYED AS
WHAT TO DO
The washer
is out of
balance.
Wash load is out of balance. Ensure the washer is
stationary. Manually redistribute the load.
Check the washer is level. (Refer to ‘Installation
instructions — Levelling instructions’ for more
information).
The washer
has too many
suds.
The washer has a suds build-up (too much detergent
may have been used for the amount of soil in the
load). Wait for suds to dissolve (about 20 min). Rinse
clothes using a deep rinse.
Check the standpipe height does not exceed 1200mm.
If the symptom persists, call your Fisher & Paykel
dealer or Fisher & Paykel trained and supported
service technician.
The lid can’t
lock or the lid
is open.
Make sure the lid is closed.
Touch
. (Refer to ‘Washer safety features — Lid lock’
for more information).
If the symptom persists call your Fisher & Paykel
dealer or Fisher & Paykel trained and supported
service technician.
The washer is
overloaded.
The washer is overloaded and can not agitate. Ensure
the washer is stationary. Remove items until the
remaining ones can move freely.
Select a higher water level.
The washer
has stopped.
The power was cut to the washer. The washer will
restart automatically. No action is required.
The washer
has stopped.
The
or ‘POWER’
button was touched and the
washer was inactive for 3 minutes. The washer will
automatically drain to a safe level. Touch any button
to stop autodraining then touch
to resume the
wash cycle.
The washer
is on but the
display is
blank.
The washer was unattended without starting a cycle
for a period of time. Touch ‘POWER’
to activate.
*
The beeps are the same sound your washer makes when you turn it on at the wall.
