Fisher & Paykel SINGLE DISHDRAWER DD24STX6HI, Руководство по установке

Страница: 22 / 24

22
TROUBLESHOOTING
No program indicator lights up when the drawer is opened
z
Ensure power is connected and is switched on.
z
AUTO POWER-ON
may need to be activated. Refer to your user guide for details.
Drawer doesn’t close properly
z
Ensure nothing is obstructing the drawer from closing such as hoses or drawer latches.
Water appears around water supply and drain connections
z
Check hoses, connections and existing plumbing for leaks.
z
Check rubber washer and hose clamp are correctly fitted.
Product is tipping
z
Ensure the product is secured to the cabinetry.
Front panels are misaligned to surrounding cabinetry
z
Check cabinetry is square.
z
Re-adjust door panels using the door adjustment screws. Refer to page 17 for guidance.
z
Re-secure DishDrawer
TM
Dishwasher to cabinetry
If a problem occurs that is not listed, refer to your user guide for additional troubleshooting If
after checking these points, you still need assistance, please refer to the Service & Warranty
book for warranty details or contact us through our website fisherpaykel.com
DISPLAY POSSIBLE CAUSE WHAT TO DO
RINSE
+ all modifiers
A1:
Water
Supply fault.
1
Ensure the water supply is turned on.
2
Press once to stop the beeping, then
again to clear the fault.
3
Press to resume the wash program.
ECO
,
RINSE
+ all modifiers
A3:
Drawer
cannot drain. The
drainage hose
may be blocked
or kinked, or the
connection to
drainage pipe may
be blocked.
1
Ensure the drainage hose and
connection to pipes are not blocked.
2
Press once to stop the beeping, then
again to clear the fault.
3
Press to resume the wash program.
1
Ensure the filter is installed correctly.
Refer to 'Replacing the filter' in your
user guide.
2
Press once to stop the beeping, then
again to clear the fault.
3
Press to resume the wash program.
GLASSWARE
,
ECO
+ all
modifiers
A6:
The spray
arm has loosened
or come off its
mounting, or
water pressure
is too low, or
a combination
of low water
pressure and
excessive foaming.
1
Open the drawer and check the
spray arm.
2
If the spray arm has loosened or
come off its mounting, re-fit it. Check
that it is firmly seated and turns
freely. Refer to 'Maintenance' in your
user guide.
3
Press once to stop the beeping, then
again to clear the fault.
4
Press to resume the wash program.