SAFETY AND WARNINGS
!
WARNING!
Electric Shock Hazard
Failure to follow this advice may result in
electric shock or death.
• Disconnect the appliance from the mains
electricity supply before carrying out any work
or maintenance.
• Connection to a good earth wiring system is
essential and mandatory.
• Alterations to the domestic wiring system must
only be made by a qualified electrician.
!
WARNING!
Cut Hazard
Failure to use caution could result in injury.
• Take care: some edges are sharp.
READ AND SAVE THIS GUIDE
General Use
z
Read these instructions carefully before installing this product.
z
Save these instructions for the local electrical inspector’s use.
z
Installation must comply with your local building and local electricity regulations.
z
Electrical installation (including electrical grounding) must be done in accordance with
the National Electrical Code, ANSI/NFPA70 – latest edition and/or local codes. In Canada:
Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical
Codes Part 1 and/or local codes. Particular attention shall be given to the relevant
requirements regarding ventilation.
z
This appliance is to be installed and serviced only by Fisher & Paykel trained and supported
service technician or qualified person.
z
The manufacturer accepts no responsibility for the incorrect installation of appliances.
Incorrect installation may result in personal injury, damage to property and may invalidate
any warranty or liability claims.
z
Do not modify this appliance.
z
Do not use or store flammable materials on or near this appliance.
z
Packing elements (eg plastic bags, polystyrene foam, staples, packing straps etc) and tools
should not be left around during and after installation, especially if they are within easy
reach of children, as these may cause serious injuries.
z
Make sure you recycle the packaging material.
z
Before disposing of any appliance, make sure that it can no longer be used and that all
hazardous parts are removed or made harmless, so that children playing with the old
appliance cannot harm themselves.
z
Only genuine replacement parts may be used for servicing the appliance. These are
available from your nearest Fisher & Paykel Service Center.
z
This cooktop must be connected to the mains power supply only by a suitably
qualified person.
z
DO NOT use adapters, reducers, or branching devices when connecting the cooktop to the
mains power supply to prevent overheating and fire.
z
The power supply cable must not touch any hot parts and must be positioned so that its
temperature will not exceed 165°F (75°C) at any point.
z
This cooktop requires adequate supply of cool air to fully function. The base of the
cooktop must have direct unrestricted ventilation to the room where the cooktop is
installed. There must be a 3/16" (4mm) air gap at the front of the cooktop (see ‘Venting
Clearances’ page).
2
