Fisher & Paykel MINIMAL CID364DTB4, Руководство по установке

Страница: 4 / 14

4
INSTALLATION CONSIDERATIONS
Please ensure the following:
z
A suitable disconnection switch is incorporated in the permanent wiring, mounted and
positioned to comply with the local wiring rules and regulations. A means of disconnection
with at least a 3mm air gap contact separation in all poles must be incorporated into the
fixed wiring in accordance with the wiring rules, unless the local wiring rules allow for
alternative means.
z
The benchtop is made of a heat resistant material.
z
There is adequate flow of cool air from the cabinetry to the base of the cooktop. You
may ventilate from adjacent cupboards, but ensure that the available air supply will not
be restricted.
z
The ventilation area must be equivalent to 6 3/16in2 (40cm2) Refer to 'Clearances'.
z
The exhaust air should not be vented into a wall, a ceiling, or a concealed space of a
building
z
The power supply cable is not accessible through cupboard doors or drawers.
z
The isolating switch is easily accessible by the customer.
z
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the cooktop.
z
The cooktop will not be installed directly above a dishwasher, fridge, freezer, steam oven,
washing machine or clothes dryer, as the humidity may damage the cooktop electronics.
z
The installation will comply with all regulations relating to the discharge of air, clearance
requirements and other applicable standards and regulations.
z
You consult local building authorities and by-laws if in doubt regarding installation.
z
The installation will comply with all regulations relating to the discharge of air.
Please ensure the following:
z
Flush mounting or sealing this appliance into the bench with silicone or glue may make
future servicing difficult. Fisher & Paykel will not be liable for any costs associated with
removing or replacing a sealed-in appliance, nor for repairing any damage that may be
incurred by doing this.
z
Seal exposed bare edges of the cutout with an oil-based paint or moisture-proof
polyurethane to prevent possible moisture creeping between the cooktop trim and
the benchtop.
z
Take extreme care not to chip, crack, or break the top glass surfaces during installation.
A heavy metal tool or part accidentally dropped on the glass could damage it.
z
If, after following the instructions given, correct performance cannot be achieved, please
contact your nearest Fisher & Paykel Authorised Service Centre, Customer Care, or contact
us through our local website listed at the end of this document.
WARNING!
The owner carries all risk for flush mounting the cooktop. The owner must ensure the
cooktop has been cut out from the countertop before servicing can be carried out.
Fisher & Paykel will not be liable for any costs associated with removing or replacing a flush-
mounted and/or sealed-in product, nor for repairing any damage that may be incurred by
doing this.
BEFORE INSTALLATION DURING INSTALLATION