• To reduce the risk of fire, use only metal ductwork. Do not use flexible plastic ducting
• To reduce risk of fire and to properly exhaust air, be sure to duct air outside – do not vent
exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.
Venting Options
Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air are fulfilled.
The ventilation hood can be installed to operate with the exhaust air ducted externally from the kitchen.
Ducted
For ducted installation it is recommended that 6” (152 mm) diameter, rigid or semi-rigid ducting is used. This will require
a 6 5/16” (160 mm) (min) round hole in the ceiling or wall. Care should be taken to position the hole correctly.
For optimal efficiency use the shortest and straightest duct route possible and use rigid or semi-rigid ducting for reduced
noise and increased airflow. Flexible metal ducting should only be used as a last resort (ie in difficult installations) and if
used ensure that it is straight and smooth and extended as much as possible.
•
This appliance is heavy and requires two persons for unpacking and installation
•
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards.
•
Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
Updated: Thu, 02 Apr 2020 06:40:38 GMT
Powered by
6