8
INSTALLATION INSTRUCTIONS
Venting options
Attention should be given to ensure that any applicable regulations concerning the
discharge of exhaust air are fulfilled.
The rangehood can be installed to operate with the exhaust air ducted externally from
the kitchen, or installed to operate with the exhaust air recirculating within the kitchen.
Ducted
For ducted installation it is recommended that 125 mm diameter, rigid or semi-rigid
ducting is used. This will require a 135 mm (min) round hole in the ceiling or wall.
Care should be taken to position the hole correctly.
For optimal efficiency use the shortest and straightest duct route possible and use rigid
or semi-rigid ducting for reduced noise and increased airflow. Flexible metal ducting
should only be used as a last resort (ie in difficult installations) and if used ensure that
it is straight and smooth and extended as much as possible.
Recirculating
To enable the product to operate
with the air recirculating, ensure
the lever on the motor casing
under the filter is in the recirculation
position (see Fig.1) and close off the
duct hole with the cover provided
(see Fig.2). Purchase and install
carbon filters (refer to the ‘Parts
and accessories’ section).
The rangehood will channel the air
out of the vent on the front surface.
The carbon filters are required to
remove odours.
Note: a ducting hole is not
required in the wall or ceiling if the
rangehood is installed to operate
with exhaust air recirculating.
Fig.1
Fig.2
Содержание HF60LW4
Страница 1: ...Standard Rangehood HF60LX4 and HF60LW4 model NZ AU INSTALLATION INSTRUCTIONS USER GUIDE ...
Страница 2: ......
Страница 4: ......
Страница 23: ......