A ducting hole is not required in the wall or ceiling if the rangehood is installed to operate
with exhaust air recirculating.
• This appliance is heavy and requires two persons for unpacking and installation
• Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards.
• Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards
Wear gloves to protect against sharp edges.
The manufacturer is not liable for any damage caused by not following these instructions.
Installation
1.
Prepare for installation.
Before installing your rangehood:
• Please read the instructions carefully.
• Unpack the rangehood and check that all functions are working.
• Ensure that the voltage (V) and the frequency (Hz) indicated on the serial plate match the voltage and frequency
at the installation site.
• Check that the area behind the installation surface to be drilled is clear of any electrical cables or pipes, etc.
• The stainless steel and glass surfaces of the rangehood are very easily damaged during installation if grazed or
knocked by tools. Please take care to protect the surfaces during installation.
• Protect the cooktop surface below with cardboard, or the like, to prevent damage occurring whilst the rangehood
is being installed above.
• Temporarily mark the height of the bottom of the rangehood and the centre of the cooktop on the wall according
to the information given in the ‘
Installation instructions – Height of rangehood
• The wall used for mounting the rangehood should have sufficient strength and a flat surface.
2.
Attach chimney brackets and hood mounting screws
• Attach the chimney bracket and upper chimney bracket (if using the upper chimney) in the locations shown in
Fig.2 and 3. Use the 30 mm screws and expansion plugs if attaching to masonry.
Updated: Thu, 08 Oct 2020 05:42:05 GMT
Powered by
9