Fisher & Paykel FabricSmart WA8060P, Руководство пользователя

Страница: 8 / 48

6
INSTALLATION INSTRUCTIONS
Unpacking
To ensure the best performance from your new washer please follow the instructions below.
Removing the packaging
1
Remove the outer packaging.
2
Tilt the washer backwards and walk it off the
base packer one foot at a time (ensure the lid
is still taped down).
3
Remove the base packer from under the
washer by tilting the washer backwards and
pulling the packer out the front.
4
Remove the tape, lift the lid and remove the
bowl packer from the bowl.
5
Remove the hoses and accessories.
6
Keep the base packer and bowl packer in case
they are required for future transit.
ImpORTANT!
Please ensure that the base packer has been removed BEFORE OPERATING
your washer.
Location
ImpORTANT!
Install the washer on a solid and level floor surface ensuring it has at least 20 mm
clearance on each side. The washer must not be installed on any textured floor
coverings (eg carpets, rugs).
In your clothes washer you will find:
● ●
1 hose guide.
● ●
2 inlet hoses.
Drain hose
1
Carefully pull the drain hose out from the back
of the washer by pulling the exposed part of the
hose downward and outward.
2
To guide the drain hose over the tub or
standpipe the hose guide MUST be fitted to the
drain hose.
ImpORTANT!
To prevent siphoning the drain hose should
not extend more than 20 mm from the end of
the guide. The height of the standpipe or tub
should be between 850 – 1200 mm. The drain
hose can be trimmed to length.
3
Place the drain hose in the tub or standpipe. Do
not fit the hose to a drain spigot. Drainage must
not be airtight in order to prevent siphoning.
Tilt washer backwards to remove packer
Pull hose
through
guide
Flex hose
guide apart
S
tandpipe 850
–
1200
mm
(20 mm)
maximum
Fitting the drain hose guide