Fisher & Paykel DW24U2I1, Руководство по установке

Страница: 6 / 23

4
Supplied parts
Drain hose support
(1) Plastic slider
(1)
Moisture protection tape for
cabinetry (1) Mounting brackets for wood
countertop or side cabinets (2)
Ø3.5 x 1/2” (12mm) screws
(4) Ø4 x 1” (25mm) screws
(4)
Ø3.9 x 1 1/2” (38mm) screws
(4) Ø3.9 x 1/2” (13mm) screws
(4)
INSTALLATION GUIDE
US CA
DW24U6I1 & DW24U2I1 models
DISHWASHER
USER GUIDE
US CA
DISHWASHER
DW24U2I and DW24U6I
models
SERVICE & WARRANTY
SERVICE ET GARANTIE
ΣΈΡΒΙΣ ΚΑΙ ΕΓΓΎΗΣΗ
SERVIZIO E GARANZIA
SERVICE & GARANTIE
HUOLTO JA TAKUU
SERVICE OG GARANTI
保 修 和 维 修
服務和保修
Installation guide
(1) User guide
(1) Service &
Warranty (1)
Utilisez ce gabarit pour percer avec précision les avant-trous destinés à la fixation
de votre panneau de porte encastré.
Déterminez la hauteur de porte appropriée ci-dessous et alignez le gabarit avec la base
de votre panneau de porte. Pour les instructions d’installation complètes, reportez-vous
au Guide d’installation fourni avec votre appareil.
Pilot holes
Centre line
Avant-trous
Ligne centrale
Use this template to accurately drill the required pilot holes in your custom door panel.
Establish the appropriate dimension below and align the template with the base of your panel.
For full installation guidance, refer to the Installation Guide supplied with your appliance.
DOOR PANEL TEMPLATE GABARIT DE PANNEAU DE PORTE
Door overhang: 2 1/8" – 2 15/16" (54mm – 74mm)
Door overhang: 1 5/16" – 2 1/8" (34mm – 54mm)
Partie saillante de la porte : 2 1/8 po – 2 15/16 po (54 mm – 74 mm)
Partie saillante de la porte : 1 5/16 po – 2 1/8 po (34 mm – 54 mm)
591518B 05.19 591518B 05.19
Door panel template
(1)
Required parts
UL-listed wire nuts
(3) Thread seal tape
(1) 3/4”(19mm)
Elbow 90° (1)
Required tools
Phillips-head
screwdriver Nutdriver
1/4” (6.35mm) and 5/16”
(7.94mm) Torque driver T25
Powered drill Adjustable wrench 6”
(152.4mm) Measuring tape
Safety glasses Torch Gloves
Bucket – for flushing
the line Tubing cutter Hole saw set
Level Carpenter’s square
Allen key 1/4” (6mm)
2 COMPONENTS 3 TOOLS
Components for new installation only
(available in hardware stores)
Air gap for drain hose
(use only if required) Waste tee for house plumbing
(use only if required)
3/4”(16mm) Strain relief for
electrical connection Screw-type hose clamps
Hot water line with ferrule and
compression nut – min 3/8”
(9.5mm) copper tubing or flexible
braided hose ØElectrical cable or Power cord
kit (5’ 4” long) or (7’ 9” long)
depending on your installation
Hand shut-off valve (recommended)