Fisher & Paykel DOUBLE DISHDRAWER DD24DTX6HI, Руководство по установке

Страница: 14 / 22

14
FIT CUSTOM DOOR PANELS
9
!0
!1
Insert a Phillips screwdriver into the
hole above each side pin and rotate
to adjust the panel alignment. There
is a maximum travel distance of
± 1/16" (2mm).
Repeat for both sides and drawers
if required.
Re-check clearances.
Ensure the minimum clearance gap
of 5/16" (8mm) between panels is
maintained after all adjustments have
been made.
Re-insert both side pins to each drawer
by pushing in and twisting a quarter-turn
towards the rear of the product to secure
panels into place.
Attach the Knock-to-Pause module to
the panels as shown.
Ensure the Knock-to-Pause modules
are oriented correctly and are
not in contact with the brackets
before securing.
5
6
Snap the bracket tab to remove.
Carefully fit the panels onto the
product. When refitting the lower
panel, we recommend pushing back the
drawer slides as shown on page 10
for access.
7
8
Electric shock hazard:
To earth the panel bracket, connect the
earth wire from the product to one of
the tabs. Any custom metal components
(e.g. handle) that extend past the
rubber seal must be earthed also.
Reconnect the Knock-to-Pause module
to the UI 1 slot on the wash controller as
shown. Reconnect the earth wire to the
panel bracket.