Fisher & Paykel DH9060P, Инструкция по установке/Руководство пользователя

Страница: 22 / 40

20
Delay Start
The ‘Delay Start’ option enables you to delay the start of the drying cycle from
between 5 minutes and 12 hours. Delayed start options are 5 minutes, 15 minutes,
30 minutes, 1 hour, then hourly up to 12 hours. This can be useful to time your drying
to finish when you arrive home from work, or to start when power rates are lower.
To ‘Delay Start’ your cycle:
1
Select the cycle.
2
Press ‘More’ to increase the delay time.
3
Press to confirm your selection and start the countdown.
4
The display will indicate the time until the cycle will start.
To decrease or turn off ‘Delay Start’:
1
Press ‘Less’ to decrease the delay start time or to turn ‘Delay Start’ off.
Avoid using ‘Delay Start’ for damp, non-colourfast items as this may cause dye run to
occur.
Drying cycle options
All drying cycles default to the recommended options for that cycle based on the
average expected load to be dried using that cycle. You can vary the options to
create your desired cycle.
After using your dryer a few times you may discover there are some drying options
you prefer for some cycles. You can programme your dryer to remember the
drying options you prefer for each drying cycle. For instance, you may want to set
the ‘Easy Iron’ cycle to a lower drying temperature or programme the ‘Everyday’
cycle so it automatically has the ‘Wrinkle Free’ option selected.
To change a drying cycle option:
1
Press ‘POWER’ to turn the machine on.
2
Turn the dial to select the cycle you wish to customise.
3
Touch and hold any of the drying options buttons for 3 seconds.
The lights will flash on and off and the display will show ‘
’ to indicate
that the machine is in cycle adjustment mode.
4
Select the drying options you prefer by touching the relevant option button.
5
Touch to save the selected settings. The dryer will beep to indicate your
customised cycle has been saved.
Note: Touching before pressing will exit the cycle adjustment mode and start
the cycle using the settings shown on the display panel.
To change the cycle or options you have selected after a cycle has started:
z
Touch and select your new cycle or options, then touch again to resume drying.
Note: Some options may not be available for selection under certain conditions
and after particular stages of the drying cycle have passed.
CUSTOMISING DRYING CYCLE