2. Stretch gasket “D” (Figs. 10 and 11) over the edge of the cutout, being careful to overlay the junction edges.
3. Turn the cooktop upside down, place it on a soft surface and fasten the brackets F and R to the appropriate
socket holes, without tightening the screws B for the moment. Make sure that the tabs are mounted correctly,
as shown. Rotate the tabs so that the cooktop can be put into the cutout.
4. Put the cooktop into the cutout and position it correctly.
5. Put the brackets F and R into place; tooth A of the brackets should go into the hole (Figs. 10 and 11).
6. Tighten screws B until the cooktop is completely secured to the bench.
7. Using a sharp cutter or trimmer knife, trim the excess sealing material around the edge of the cooktop. Take
care not to damage the workbench.
Fig. 8 CE302 models
Fig. 9 CE604 models
Fig. 10 CE604 models rear side
https://producthelp.fisherpaykel.com/au/Cook/Cooktops/Electric/Two_Burners/CE302CPX1/User_Guide_CE302CPX1/02_Installation_instructions
Updated: Sat, 09 Mar 2019 07:23:30 GMT
Powered by
5
