Fisher & Paykel 92188, Руководство по обслуживанию

Страница: 13 / 30

427939
13
6.4 Rear Panel Removal
1. Remove the 16 screws from around the edge of the panel.
Note:
It is not necessary to remove the exhaust flange when fitted
Reassemble in the reverse order
6.5 Drum Removal
1. Remove the top panel and the rear panel Refer to sec 6.3 & sec 6.4
2. Remove the wires connected to the element.
3. Remove the thermostats by unscrewing the bracket holding them
4. Provide a suitable floor covering to protect door and front of cabinet from being marked. Then
lay dryer on its front.
5. Take off the belt tension from the drum at the jockey pulleys – remove belt from motor pulley.
6. Remove the earth wire screw from the heater plate.
7. Remove the 4 screws that hold the element plate brackets to the sides of the cabinet.
8. Pull the drum away from the front of the cabinet.
Reassemble in the reverse order. Ensure that the drum belt is over the drum before assembly.
Check felt seal.
6.6 Replacing Front Drum Bearings DE50F56
NOTE
: This can only be done with the drum removed, refer to sec 6.5, once removed stand the
cabinet upright.
1. Remove 7 screws that hold the bearing support ring to the air duct.
2. The bearing ring can be removed from the air duct.
3. There are 6 drum bearings fitted to this ring which are removed by pushing them out.
4. When fitting the replacement drum bearings, check the surface on the front edge of the drum
that the bearings’ run on to ensure it is free from grease and rough surfaces etc.
Reassemble in reverse order.
NB. Ensure that the chamfer along the long edge is fitted facing toward the rear of the machine.
6.7 Replacing Front Drum Bearings DE40F56
1. Remove the drum refer to sec 6.5.
2. Push the 6 existing bearings out
3. When fitting the replacement drum bearings, check the surface on the front edge of the drum
that the bearings’ run on to ensure it is free from grease and rough surfaces etc.
Reassemble in reverse order.
NB. Ensure that the chamfer along the long edge is fitted facing toward the rear of the machine.
6.8 Replacing the Rear Drum Bearing
1. Remove the drum refer to sec 6.5
2. Remove the drum bolt, cap and spacers from inside the drum.
3. Remove the outer screws holding the bearing housing to the drum rear.
4. Remove the screws holding each half of the bearing housing together.
Reassemble in reverse order. Ensure that the bearing housing clamps the outer ball race shell
securely (across the bearing face not on the diameter) and that the correct drum spacer is fitted to
the inside as the outside spacer is recessed.
6.9 Bearing Holder, Air Duct Assy and Felt Seal
Removal DE50F56
1. Remove the Drum refer to sec 6.5
2. Remove air duct tube from front air duct assy. Just pulls off.
3. Remove 7 screws that hold air duct assy to the front of the cabinet.
4. Duct can be pulled away from the front of the cabinet.
Reassemble in reverse order, taking care to ensure that the air duct gasket fits around the edge of
the duct and does not fold over when fitted to the cabinet.