FB21052
Jeep® TJ Wrangler 1997-2006
TJ Winch Plate
2
2105200
equipped). If running an aftermarket bumper, use
the proper socket to remove the top four (4) bolts.
Remove only the two (2) front stabilizer mounting
bolts. DO NOT remove the stabilizer mounting bolts
that are located between the stabilizer bar and the
grille.
2)
PREP YOUR NEW WINCH PLATE FOR INSTALL
Before installing your winch plate on your Jeep, you
will need to attach your winch and fairlead. Install
these per the manufacturer’s instructions in the pre-
drilled holes on your new winch plate. M10x35mm
bolts and lock nuts have been provided in this kit for
the fairlead if needed.
3)
INSTALL YOUR WINCH PLATE
Place the winch plate on the front bumper and align
the mounting holes.
Depending on your current bumper configuration,
you may need to utilize the spacers included in this
kit. Place these spacers between the frame and
winch plate at the location of the front stabilizer
bolts. Use the supplied M10x50mm hex bolts at
these locations.
Using the supplied ½” hex bolts and flat washers,
secure your winch plate in place.
4)
RUN YOUR WIRING
Wire your winch according to the winch
manufacturer’s instructions.
5)
ENJOY YOUR NEW FISHBONE OFFROAD WINCH
PLATE!
