17
B
l u e t o o t h
C
o n t r o l
S
e t
o
p e r a t i n g
m a n u a l
●
Select button (5)
Press briefly: LED changes colour from blue to yellow. The frequency is switched to a second
receiver, which can be connected to and controlled by the same transmitter, without the first
receiver being negatively influenced (see also Chapter 8). Continuing to press the button changes
back to the first receiver (blue).
Pressing long (approx 3 sec.): Pairing mode is activated. The LED flashes rapidly (approx. 4x per
second). Pairing mode remains active for approx. 30 sec. If during this time there is no receiver
found it is switched off again. During the 30 sec. the pairing mode can be immediately switched
off by briefly pressing the button.
●
ON button (2)
Pressing this button switches on the transmitter. The LED (1) lights up blue or yellow depending
on which receiver was set last.
If no joystick is moved on the transmitter for an extended time, the transmitter switches off to
save battery power. You can then switch the transmitter back on simply by pressing this button.
●
OFF button (7)
The transmitter is switched off by pressing this button for approx. 3 sec.
●
Battery compartment (1)
The 9 V block battery 6F22 is located in this compartment on the bottom of the transmitter (not
included in the scope of delivery) for power supply of the transmitter. To insert or to change the
battery, loosen the locking screw of the battery compartment and then remove the cover by pressing
on the locking tab. The battery is connected with a type of pushbutton. Important! The plug only
fits in one specific position on the battery. Then place the cover back on and tighten the screw.
