Firstech CM600-AS, Руководство по установке

Страница: 18 / 24

18
2-12
Ground When Armed
– Ground When Armed or GWA, at default setting will send a constant
latched negative output when armed and remote started on the blue wire on CN3. This is used to
trigger your starter kill relay and prevent overgrinding on the vehicle's starter. The optional setting
turns the output into a latched GWA only. Optional setting 4 will make the blue wire an Auxiliary 4
which is programmable by your OP500 Option Programmer.
2-13
Advanced Tachless -
This feature when used in conjunction with feature 2-04 option 3 will
provide an enhanced Tachless engine sensing mode.
3-01
Secure Aux Output
– On the default setting, trunk and star buttons must be held for 2.5 seconds
before Aux 1 or Aux 2 can be triggered. This prevents accidental triggering of the outputs. Option
setting 2 turns this feature off.
3-02
Aux 1 Output - This option determines the duration of the Aux 1 output. Setting 4 allows the
output duration to be set for a specific length of time.
3-03
Aux 2 Output - This option determines the duration of the Aux 2 output. Setting 4 allows the
output duration to be set for a specific length of time.
3-04
Aux 1 Output Control
– This option sets the condition which controls Auxiliary 1 and how it is
triggered. Please see the option table 3 for details.
3-05
Aux 2 Output Control - This option sets the condition which controls Auxiliary 2 and how it is
triggered. Please see the option table 3 for details.
3-06
Auxiliary Input 1
– This option changes the input condition on the gray/white wire on CN3.
Default 1:
Will pre-warn with a negative (-) ground input.
Option 2: Will arm the system with a negative (-) ground input. Used when adding an alarm to a factory keyless entry
system.
Option 3: Turns the wire into a closed loop trigger. Can be used to detect if the circuit is broken like for a trailer
connected to the truck hitch.
Option 4: Turns the wire into a (-) ignition input that bypasses the instant trigger wire and shock sensor.
3-07 Auxiliary Input 2
– This option changes the input condition on the black/white wire on CN3.
Default 1:
. Will instant trigger with a negative (-) ground input.
Option 2: Will disarm the alarm with a negative (-) ground input. Used when adding an alarm to a factory keyless entry
system.
Option 3: Turns the wire into a (-) Key Sense wire. If the wire sees a negative trigger it will not allow the system to arm.
Option 4: Turns the wire into a (-) Parking Light Reminder input. If the wire sees a negative trigger during arm it will
chirp the siren and flash parking lights 5 times to notify the user that their parking lights are still on.
3-08 Shock Sensor Inputs
– This option changes the behavior of the 1
st
Stage or 2
nd
Stage input
wires. When Option 2 or 3 is set and the system is armed or disarmed and sees ground on either
wire, the CM600-AS will not arm or disarm.
4-01
Connector 2, Pin 1 - This option will change the behavior of the green/white wire on Connector 2
(CN2). At default the wire will act as negative parking light output but can be changed to (-)
accessory or ignition.
4-02
Connector 2, Pin 3 - This option will change the behavior of the green/white wire on Connector 2
(CN2). At default the wire will act as negative parking light output but can be changed to (-)
accessory or ignition.