Alarm rearm and lock
To rearm, hold your finger on the ‘Red Circle’ for 2.5 seconds.
Alarm disarm and unlock
To disarm, hold your finger over the ‘Red Circle’ for 2.5 seconds. Once the LED’s start their circular
pattern, enter your 4 digit code. (Refer to Step 4 above.) Two seconds after entering the 4th digit, your
system will disarm.
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the ‘Red Circle’ twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver’s door, hold the button on the back of the RPS Touch until the LED’s go
out. Release button and tap again. The number of solid LED’s represent sensitivity of touch, 1 being the lowest, 5
the highest.
RPS (Remote Paging Sensor) Unlock/Disarm
RPS and car call functions do not require programming, however in order to unlock/disarm your vehicle you must
program a 4 digit passcode using the instructions below:
STEP 1:
Disarm/unlock the alarm (remote must be programmed first) and choose a 4 digit code. You can not have
zeros.
STEP 2:
Turn ignition key to the “on” position and leave the driver’s door open.
STEP 3:
Knock on the windshield in front of the RPS a total of 5 times (each time you knock the LED on the RPS
will flash RED). The LED will begin to flash rapidly in BLUE with successful completion of this step.
STEP 4:
Enter the first digit of the desired four digit pass code by knocking on the windshield in front of the RPS the
desired number of times. For example, to enter 3, knock on the sensor 3 times (each time you knock the LED will
flash RED) then wait.
STEP 5:
The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED begins to flash
rapidly in BLUE, enter your second number by repeating step 4.
STEP 6:
Repeat steps 4 & 5 to enter all four numbers.
STEP 7:
Turn the ignition OFF - the RPS disarm/unlock passcode is now programmed. Follow steps 3 – 5 to enter
your disarm/unlock code.
Alarm rearm and lock
To rearm, knock on your sensor 5 times.
Alarm disarm and unlock
To disarm, knock on your sensor 5 times. Wait for the Blue LED’s to flash rapidly. Follow STEP 4 and 5
above to enter your 4 digit passcode.
2 Way LCD remote paging
To page a 2 Way LCD remote just knock on the RPS twice.
Knock Panel Sensitivity
To change knock sensitivity, disarm the system and adjust the switch on the rear of the RPS. The larger the circle,
the more sensitive the knock sensor is.
More Optional Sensors
If you purchased an Alarm or Alarm and Remote Start system, you can add additional sensors from Firstech.
Protect your investment by adding a battery back up system to protect main power or a FT-DAS sensor to protect
custom wheels and tires.
