FT-DAS
STEP 1:
Turn the ignition to the ‘on’ position.
STEP 2:
2 Way remotes-hold buttons 1 and 2 (Lock and Unlock) for 2.5 seconds. You will get two parking light
flashes. 1 Way remotes-hold Lock and Unlock for 2.5 seconds. You will get two parking light flashes.
STEP 3:
To set the Warn Away Zone 1, tap button 1. (1 Way: Lock) After you get one parking light flash, tap the
vehicle. You will get siren chirps 1-most sensitive through 10-least sensitive. This sets the impact sensitivity of Warn
Away Zone 1.
Setting Zone 1 will automatically set Zone 2. If you would
like to manually set Zone 2 proceed:
To set Instant Trigger Zone 2, tap button 2. (1 Way: Unlock) After you get two parking light flashes, tap the vehicle.
You will get siren chirps 1-lowest through 10-highest. This sets the impact sensitivity of Instant Trigger Zone 2.
STEP 4:
Once you get two parking light flashes, you are ready to test your DAS.
FT-Shock
Adjusting the shock sensor sensitivity is done at the actual sensor, which is generally mounted somewhere under
the vehicle’s dashboard. The higher the number on the dial means greater sensitivity to impact. The recommended
dial setting for most vehicles is somewhere between 2 and 4. If you are testing your sensor, please note that the
shock sensor does not recognize impact for 30 seconds after the system has been armed.
Advanced Features
The following section reviews advanced system functions. Many of these functions require multiple steps or
additional programming by your local authorized dealer.
RPS Touch and RPS (Remote Paging Sensor)
The RPS is an optional feature. The car call/RPS feature uses a small sensor that is mounted on the inside of your
windshield.
RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and arm/lock. All
features are operated with a simple touch of the sensor.
Please have your installer program the RPS Touch controller settings.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your vehicle you
must program a 4 digit passcode using the instructions below:
STEP 1:
Choose your RPS Touch 4 digit code. ‘0’ is not available.
STEP 2:
Turn ignition to the ‘ON’ position and leave driver’s door open.
STEP 3:
Hold your finger over the ‘Red Circle’ icon for 2.5 seconds.
STEP 4:
When the siren chirps and LED’s flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get one siren
chirp and LED’s will flash in a circular pattern.
STEP 5:
Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
