FIRST STOP SAFETY
7
POWER CORD
When this button is pressed, the unit will carry out an Earth Continuity,
Insulation Resistance and a Polarity test showing the results for each test
and an overall PASS or FAIL.
LONG LEAD
This is used when appliances and power cords exceeding 10m in length
are being tested. With this function, the BattPAT can test appliances and
power cords up to 40m in length.
BATTERY CHARGING
When the battery capacity is low, a battery Low LED will start to flash
warning the user to recharge at the next available opportunity. If the
battery charge is too low, the unit will not operate.
When the charger is first plugged in a fast charge is applied for two hours.
During this period, the charge LED flashes. After this the battery is
charged at a lower rate for another 6 hours. The charge LED is on steady
during this time. The BattPAT can be powered using the charger if the
battery is flat.
SHORT IEC LEAD
This allows mains extension leads to be tested easily.
SAMPLE FORMS
An “Equipment Register” and a “Equipment Test Record” form is
included. These can be copied and used as often as required. The user
manual refers to this under the relevant sections.
LABELS
100 ‘tested’ labels, 5 ‘failed’ labels and 50 fuse labels are supplied with
each unit. Additional labels are available to purchase separately.
SELF TEST
The BattPAT has a built in self test feature. If the test voltages or currents
are outside the expected range, then it will not carry on with the testing.
The overall PASS and FAIL LEDs will flash to indicate a problem. If this
were to happen, then contact your supplier.
BattPAT
Issue 2.
