First Degree Fitness VX-2 Fluid Rower, Руководство пользователя

Страница: 9 / 22

9
Step 3. Align the Frame Tension Cable eyelet with the Bracket on lower frame
and install with M10x40mm Bolt, 4x M10 plastic washers (2 either side of eyelet
and inside the metal bracket) and Nylock nut.
Then, align and screw the opposite end into the Rear Leg as shown. Tension
until taut and then secure with Retaining Nut.
Carefully lower the rower to its normal operating position to
complete assembly with S-bend installation and Frame
Tension Cable.
Step 1.
Install rear of S-bend onto the Upper Frame using
M10x80 mm bolt, M10 Nylock and 2 x M10 washers.
Step 2 . Attach the S-bend to
the Footplate as shown. Tilt the
upper frame slightly forward to
align in the proper position.
Note the M10x15mm S-bend
bolt with washer is pre-installed
on the S-bend for your
convenience.
Installing the S-bend and Frame Tension Cable
Retaining Nut.
S-Bend