First Degree Fitness Titan Rower, Руководство пользователя, Страница: 16 / 21

Troubleshooting:
Fault Probable Cause Solution
Water changes color or becomes
cloudy. Rower is in direct sun-
light or has not had
water treatment. Change rower location to reduce direct ex-
posure to sunlight. Add water treatment and
blue dye or change tank water as directed
in the water treatment section of this manu-
al.
Rower belt slipping off belt/ bungee
pulley. Bungee not under
enough tension. Tighten bungee cord following the instruc-
tions given in the change bungee section of
this manual.
Front leg rises slightly during
vigorous rowing M10x180mm vertical
seat rail bolt is slightly
too loose. Tighten bolt 1/2 turn and try again. Tighten
as needed until problem stops. Note: Over
tightening this bolt can damage the seat
rail. Only tighten bolt until mid leg begins to
lift slightly from the ground. Refer to “Fine
tuning the Titan Rower ” for details.
The Titan Rower computer does not
illuminate after battery installation. Batteries installed in-
correctly or need re-
placing. Reinstall batteries in correct position and try
again. If the LCD screen fails to illuminate,
replace batteries. If this fails, contact your
local service center.
Titan Rower Computer screen
illuminates, but does not register
when rowing. Loose or failed con-
nection. Rower Seat
installed backwards Check that the computer lead is connected
properly. Confirm that the seat is installed
correctly.