9
Assembly
CONTINUED
TANK FILLING AND WATER TREATMENT
c) Secure right and left handle onto
corresponding crank arms by screw-
ing the handle counter- clockwise
using the Multi-tool
[
12
]
d)
Re-assemble the M8 Bolt and M15
Washer onto the handle on each side
using the 6mm Allen Key
[
11
]
NOTE: Handle threads have a blue coating which will feel very tight when threaded on-
to crank arm. This is a type of thread locker, which once in contact with the
crank arm will cause threads to activate. Note: Allow 15 minutes for the
thread locker to activate before first time use. Check pedal tightness periodi-
cally thereafter with a 15mm wrench. DO NOT USE IF NOT TIGHT.
-
Multi-tool
CAUTION:
USE A DROP CLOTH UNDER THE TANK WHEN TO AVOID STAINING
FLOOR COVERING
WARNING: IMPELLER BLADES ARE SHARP! DO NOT PLACE FINGERS IN TANK TO
ADJUST IMPELLER POSITION. IT IS RECOMMENDED TO USE THE END
OF THE HOSE SHOULD THE IMPELLER REQUIRE ADJUSTMENT.
a)
Filling requires a large bucket (not supplied) and the supplied water funnel and
hose. Filling will take approximately 8 litres of water.
b)
Open the yellow fill plug on the back of tank and insert hose (rotating the im-
peller slightly may be necessary to allow the hose to pass). In areas where tap
water quality is known to be poor, F D F recommends the use of distilled wa-
ter.
c)
Move the tank adjuster handle to level 20 and begin filling. Do not fill the tank
higher than the level indicator on the front of the clear shell.
d) Once filling is complete follow the water treatment schedule below.
INITIAL WATER TREATMENT
a) Add One Water Treatment Tablet per full tank.
Do NOT, UNDER ANY CIRCUMSTANCE, USE A
WATER TREATMENT TABLET OTHER THAN
THOSE SUPPLIED YOU’RE YOUR UNIT. Your
unit purchase includes 4xWater Treatment
Tablets, which is sufficient for several years of
use.
Note: the low-
er tank plug is
permanently
sealed
Yellow tank fill plug
Water Funnel
and Hose sup-
plied with unit