22
Fault
Probable
Cause
Solution
Tank internal surfaces
show green deposit.
Rower is in direct
sunlight or has
not had water
treatment.
Add water treatment or change tank water
as directed in the water treatment section
of this manual.
Knocking noise from
inside the control arm
while training, espe-
cially when changing
directions.
Chain requires
tightening or ad-
justment.
Open inspection plate located on front of
control arm and check tension using a
screwdriver or other tool. Use the chain
tensioning bolts located at the rear of the
control arm to tighten or adjust as needed.
The chain should have approx 3mm of
slack when properly adjusted. See P.6 for
details.
HandGrips slip during
hard training.
PK tank belt re-
quires tightening.
Remove large inspection plate next to the
tank, insert a long tool to push the rear
end cap out from the inside, exposing the
tank belt tensioning bolt. Loosen tank
bolts slightly. Remove upper rubber belt
cover to expose the PK belt. Tighten the
tank tensioning bolt until the belt is too
tight to be twisted from side to side more
than 45 degrees by hand. See P.15 for
details
HandGrip is loose
(either left or right)
and cannot be retight-
ened.
Crank arm
threads are
stripped.
Contact service center for replacement.
Then check weekly as recommended.
Computer screen illu-
minates, but does not
register when rowing.
Loose or failed
connection. Sen-
sor gap too wide
(see erratic com-
puter display).
Check that the computer lead is con-
nected properly. If connected properly,
check sensor gap. Open main inspection
cover and check behind magnetic ring.
Sensor head to ring gap should be no
more than 2.5mm.
The E920 computer
does not illuminate
after battery installa-
tion.
Batteries installed
incorrectly or
need replacing.
Reinstall batteries in correct position and
try again. If the LCD screen fails to illumi-
nate, try rotating the batteries slightly in
the computer. If this fails, contact your lo-
cal service center.
The E920 computer
display is erratic/slow
while displaying RPM
and WATTS
Gap between
sensor and mag-
netic ring is too
wide.
Once inspection plate is removed, check
behind magnetic ring and inspect sensor
head/ring distance. Gap should be 2.5mm
wide or less. Check Magnetic ring for
wobble.
Troubleshooting Guide:
Содержание Fluid E920
Страница 1: ...Owners Manual Wheelchair Accessible ...
