First Degree Fitness DaytonaChallenge AR, Руководство пользователя

Страница: 20 / 23

20
Bungee Shock Cord
Bungee Pulley
Removing the Bungee Shock Cord
4.Rethread the Bungee Shock Cord (on
opposite side of the Idle Wheel) back
through the Bungee Pulleys and tie off
at the Attachment Point.
Bungee
Shock Cord
Bungee Attachment
Upper Frame
Upper Frame Hole
Belt/ Bungee Pulley
First, move the Rowing Handle to it’s far-
thest forward point on the Mainframe,
then cut the plastic end tie and follow the
drawing above for bungee removal.
Next, remove the Upper Frame Plug to
allow the Bungee Shock Cord to be
threaded through the top of the frame.
Note: You will need to rotate the Belt/
Bungee Pulley to align the holes proper-
ly. Should the belt drop off of during the
bungee change, please refer to the previ-
ous pages for “Attaching/Reattaching
the Fluid Rower Belt”.
Once Bungee Cord and Upper Frame
Hole are aligned, push the Bungee Cord
up and through the frame as shown.
Hint
If Bungee Shock Cords previous tension seemed
correct (a good way to judge is if the Fluid Rower
Handle can make it to the furthest point forward
on the top of the Mainframe under bungee ten-
sion alone) then simply tie off at previous posi-
tion. If the return is too slack, experiment by
the tension in small increments and testing until the correct tension is achieved. If
the Fluid Rower Handle cannot reach the end of the seat rail during a rowing
stroke, then the Bungee Shock Cord is over-tensioned.