First Choice T2 Polis MC18, Руководство пользователя

Страница: 34 / 42

33
The light bulb should be replaced with one of equal power (75W
E27).
Remount the light door being careful the wires are in the right
position.
10.2. Electrical diagram
Figure 10-3 shows the electrical set up at 400 Vac. Figure 10-4
shows the electrical set up at 230 Vac.
10.3. Adjustment for different feed voltages
WARNING! to adapt the equipment to work at different feed
voltages from that indicated on the initial set up label, three
alterations have to be made:
1) to the cabling for resistor wires.
2) to the cabling for the feed to the control panel
3) the removal of the old label and the application of a new one.
Carry out all three alterations with care as otherwise the
equipment may be unsafe.
10.3.1. The cabling for the resistor wires
Disconnect the plug from the electrical panel. Remove the guard
from the switchboard and disconnect all the wires from the
remote-control switches’ resistors and reconnect them depending
on the voltage.
10.3.2. The cabling for the feed to the control panel
Detach the BLUE wire from the lower remote-control switch and
reconnect it depending on the voltage.