![First Alert Onelink Safe & Sound Скачать руководство пользователя страница 9](http://html1.mh-extra.com/html/first-alert/onelink-safe-and-sound/onelink-safe-and-sound_user-manual_2293355009.webp)
9
Setup & Installation
~
DANGER: ELECTRICAL SHOCK HAZARD.
Turn off power to the area where
you will install this unit at the circuit breaker or fuse box before beginning installation. Failure to
turn off the power before installation may result in serious electrical shock, injury or death.
!
WARNING:
Make sure the alarm is not receiving excessively noisy power. Examples of noisy power
could be major appliances on the same circuit, power from a generator or solar power, light dimmer on the
same circuit or mounted near fluorescent lighting. Excessively noisy power may cause damage to your alarm.
!
WARNING:
Installation of this unit must conform to the electrical codes in your area; Article
760 of NFPA 70 (NEC), NFPA 72, NFPA 101; SBC (SBCCI); UBC (ICBO); NBC (BOCA); OTFDC
(CABO), and any other local or building codes that may apply. Wiring and installation must be
performed by a licensed electrician. Failure to follow these guidelines may result in injury or
property damage. This unit must be powered by a 24-hour, 120VAC pure sine wave 60Hz circuit.
Be sure the circuit cannot be turned off by a switch, dimmer, or ground fault circuit interrupter.
Failure to connect this unit to a 24-hour circuit may prevent it from providing constant protection.
Tools You Will Need:
•
Needle-nose pliers or utility knife
•
Wire strippers
•
Standard phillips screwdriver
•
Ladder
Before you begin, ensure the Android device is updated to 5 or later and iOS device is updated to iOS 10.0 or later, then
download the free Onelink Home App from the App Store or Google Play and follow the installation and setup instructions.
NOTE:
You must enable iCloud Keychain to use Onelink Safe & Sound on an iOS device. On your iOS device, tap
Settings > [your name] > iCloud, tap Keychain and slide to turn on iCloud Keychain, follow onscreen instructions.
This smoke/CO alarm is designed to be mounted on any standard wiring junction box up to a 4-inch (10 cm)
size, on the ceiling. Read “Where to Install” and “Where Not to Install” before you begin installation.