15
The Alarm Silence Feature
This feature is intended to temporarily silence the horn while you identify and correct the problem. Do not
use the Silence Feature in emergency situations. It will not correct a CO problem or extinguish a fire. The
Silence Feature can temporarily quiet an unwanted alarm for several minutes. You can silence this smoke/
CO alarm by pressing the Test/Silence button on the side of alarm for at least 3-5 seconds or via the Onelink
Home App. After the Test/Silence button is released, the Red LED stops during the silence mode.
Silence the End of Life Signal
This silence feature can temporarily quiet the End of Life warning “chirp” for up to 2 days. You can silence the End of Life
warning “chirp” by pressing the Test/Silence button or via the Onelink Home App. The horn will chirp, acknowledging
that the End of Life silence feature has been activated. After approximately 2 days, the End of Life “chirp” will resume.
Using the Silence Feature
!
WARNING:
Never discharge the unit to quiet an unwanted alarm.
Discharging the alarm disables the unit and removes your protection.
When the Smoke Alarm Is Silenced
When the CO Alarm Is Silenced
The smoke alarm will remain silent for up to 15
minutes, then return to normal operation.
The CO alarm will remain silent for up to 4 minutes.
If the smoke has not cleared or continues to
increase, the device will go back into alarm.
After 4 minutes, if CO levels remain potentially
dangerous, the horn will start sounding again.
Factory Reset
This feature is intended to reset the alarm to the original factory settings. There are two ways to
reset the alarm to factory settings.
1.
Press the Test/Silence button located on the alarm 3 times.
2.
From the Onelink Home App.
