Trimming the hair around the dog’s neck where the stainless steel probes
will touch the skin is optional,
DO NOT
trim the hair so short that the skin
is completely exposed as this might allow for an irritation or rash to occur.
Use a wrench when assembling or disassembling the stainless steel
probes, do not over tighten. (
fig. 6)
STep 3:
Close and lock clasp. (
fig. 7)
STep 4:
Adjust for proper fit by pulling on strap until you can fit two
fingers in between your dog’s neck and the collar. (
fig. 8)
Note:
Verify that the inward microphone is directly over the dog’s
voicebox. The collar should be firm but not excessively tight.
STep 5:
Let your dog wear the product for sufficient time confirming that
they are moving around normally. This step is to ensure that under daily
activity the collar will remain secure and not become loose.
STep 6:
Remove collar from dog and cut the excess collar material,
leaving approximately 1 inch.
STep 7:
Seal the edge of the collar using a flame.
STep 8:
Reattach collar to your dog. Check the fit of the collar several
times per day. Wipe the stainless steel probes weekly with a damp cloth
while collar is in off position.
Reminder:
If you choose to use a 2nd collar, leash or harness system
make sure it does not interfere with the operation of the First Al
e
rt™
Bark Control Collar.
READY TO USE
Note:
The
BATTeRY INSTALLATION
and
COLLAR
FITTING
steps must be
completed before you are ready to use.
STep 1:
Holding the main body of
the First Alert™ Bark Control Collar
in both hands PRESS and HOLD the
Control Button for 4 seconds.
Note:
The unit will beep and flash
indicating which correction level is
in use. Please refer to the correction
level settings chart under Product Overview on page 3.
Содержание FaBCSS1 SERIES
Страница 1: ...INSTRUCTION Manual FABCSS1 SERIES ...
