First Alert FaBCSS1 SERIES, Инструкция по эксплуатации

Страница: 4 / 10

HOw IT wORkS:
The First Alert™ Bark Control Collar has a proprietary bark detection
system that uses a dual microphone system to determine barking
behavior. This specially designed system ensures that a correction is
administered only when unwanted barking behavior is occurring. The
system also has been designed to prevent continuous corrections if
excessive barking is detected.
AN OveR CORReCTION MODe causes the system to turn off and
automatically reset.
OPERATING INSTRUCTIONS
Battery InstallatIon:
IMpORTANT: This step is to be completed when the collar is NOT on
your dog.
• Remove two screws securing the battery
compartment using a cross head or Phillips
head screwdriver. (
fig. 1)
• Lift battery compartment from main body of
bark collar. (
fig. 2)
• Insert two CR2032 Lithium coin batteries into
battery compartment. Batteries should be
placed with the positive side facing down.
IMpORTANT: Follow orientation as described on
graphics illustrated on battery compartment.
(
fig. 3)
• Replace battery compartment with two CR2032
Lithium coin batteries back into main body.
• Tighten the two screws using the cross head
screwdriver, do not over tighten.
• To test the unit turn on by pressing and holding
the main control button for 4 seconds. The unit
will beep and flash indicating which correction
level is in use. Please refer to the correction level
settings chart under Product Overview on page 3.
• To turn off the unit, press and hold the main
control button for 4 seconds. The unit will
beep up to three times after two seconds.
Continue to press and hold for another two seconds
until you hear a long beep and the unit is off.
figure 3
figure 1
figure 2