1. Locate Metal Shelf
Clips inside the safe.
4. Carefully place shelf on top of the clips.
5. To remove clips, squeeze the clip with your hand or pliers and lift up.
2. Insert the top
of the clip into
the notch.
important
Four (4) clips are required for each shelf. Make sure all four (4)
clips are in alignment before moving on to step 4.
3. Push the bottom
of the clip into
the lower notch.
1. Write down your new six (6) digit passcode before you proceed.
2. Enter “zero” six (6) times 0-0-0-0-0-0. (The lock will beep two (2)
times indicating that you are in the programming mode).
3. Within four (4) seconds, enter your existing six (6) digit passcode
one (1) time. (The lock will beep two (2) times).
4. Within four (4) seconds, enter your NEW six (6) digit passcode.
(The lock will beep two (2) times).
5. Enter your NEW six (6) digit passcode again. (The lock will beep two (2)
times).
NOTE:
Three beeps indicates that the old passcode is still valid).
6. If a mistake is made, wait thirty (30) seconds and repeat steps
1-4.
7. Test your new passcode several times before closing and locking the safe.
lock-out penaltY:
• Entry of four (4) consecutive incorrect passcodes starts a five (5) minute
lock-out period. (LED flashes red at ten (10) second intervals).
• At the end of the lock-out period, two (2) more consecutive incorrect
passcodes will restart an additional five (5) minute lock-out period.
• The battery must remain connected. Removing the battery will not
override the lock-out period.
caution
When selecting a passcode, do not use a birthday or other predictable data that
could give correlation between the user and passcode. keep the passcode secret.
10
9
SHeLF inStaLLation
NOTE:
Determine desired height and layout of shelves before you begin installation.
oPen tHe SaFe door
1. Enter your existing six (6) digit
passcode and open the door.
ProGraMMinG
ProGraMMinG tHe LocK
NOTE:
If you are changing the passcode
for the first time, your existing
passcode will be 1-2-3-4-5-6.
2. With the door open, turn the handle
counter-clockwise to lock the door bolts.
