Firmtech FZ200BS, Руководство пользователя

Страница: 22 / 36

FZ200BS Manual VERSION 0.1.0
22
3. Do not change the Device Type of FZ200BS once the Zigbee Network is configured.
※ It is better to set Coordinator and Router again(Factory Reset) if the Device Type of FZ200BS is
changed after the Zigbee Network is already configured.
※ See if the Zigbee Network is configured before resetting FZ200BS to initial set value. The FZ200BS
reset automatically participates in the Zigbee Network if the Zigbee Network still exists there.
9-2-1. FZ200BS End Device Set-up
(1) The Initial set value of FZ200BS is ROUTER.
(2) FZ200BS device and the PC is connected and powered ON.
After running the HyperTerminal program, FZ200BS When you
reset the serial port "ROUTER START ERROR" is output.
“ROUTER START ERROR” means that The Zigbee Network
Participation is failed. “ROUTER START OK” is output if the
Zigbee Network is configured.
(3) Input “+++” in Hyper Terminal.
(4) If “OK” is outputted from FZ200BS, AT-Command can be
used from then.
If “OK” is not output even after inputting “+++”, press “Enter”
key and input “+++” again, or reboot the device and input “+++”.
(5) After inputting “AT+SETEND” into Hyper Terminal, press Enter
Key.