Firmhorn Avenue ECO power, Оригинальная инструкция по эксплуатации

Страница: 14 / 15

29
EN
Maintenance and cleaning
1. Remove the sweeping container from the
sweeping machine, see section “Empty
sweeping container” in Section 7.5 of this
operating manual.
1
2
3
4
Fig. 12: 'XVW¿OWHUUHPRYDO
2. 3XOOWKHGXVW¿OWHUXSIURPWKHJXLGHV
3. 2SHQWKHSODVWLFKRXVLQJRIWKHGXVW¿OWHU
and remove the foam insert (4).
4. Pound out the foam insert (4) and clean it with
water.
5. Place the dry foam insert back into the plastic
housing.
6. 6OLGHWKHGXVW¿OWHUEDFNLQWRWKHJXLGHV
7. Insert the sweeping container into the
sweeping machine.
9.3 5HPRYHEORFNDJH
• Remove wound-up material (e.g. cords,
threads, etc.) from the brooms and axes.
• Remove jammed material (e.g. stones, twigs,
leaves etc.).
WARNING
)LUHKD]DUGGXHWRLPSURSHUKDQGOLQJRID
fan or the use of an unsuitable fan!
:KHQDOLJQLQJWKHEULVWOHVWKHUHLVDULVNRI¿UH
if they are heated to too high temperatures.
• 'RQRWXVHRSHQÀDPHVRUIXUQDFHWRKHDW
the bristles!
• Do not use a hot air blower. If the air is too
hot, the bristles may melt.
Bent bristles can be straightened out again
with heating by means of a warm air fan (e.g.
hairdryer).
• Point the switched-on warm air fan towards
the bent bristles.
» ,IWKHKHDWLQJLVVXႈFLHQWWKHEULVWOHVZLOO
straighten out again by themselves.
9.5 Clean the device
• Do not use a degreasing agent.
• Do not use any aggressive cleaning agents.
• Do not clean the device with a high-pressure
cleaner or under running water. The device
may not be immersed in water or cleaned with
water.
• Protect the bearings against moisture.
• 'RQRWFOHDQWKHSODWHEURRPVDQGWKH¿QHGLUW
sweeping roll with compressed air.
» The strong air jet can damage the bristles.
1. &OHDQWKHSODWHEURRPVWKH¿QHGLUWVZHHSLQJ
roll and the drives with a wet cloth.
2. Clean all plastic parts with a damp cloth.
)LUHKD]DUGGXHWRLPSURSHUKDQGOLQJRID
fan or the use of an unsuitable fan!
:KHQDOLJQLQJWKHEULVWOHVWKHUHLVDULVNRI¿UH
if they are heated to too high temperatures.
• 'RQRWXVHRSHQÀDPHVRUIXUQDFHWRKHDW
the bristles!
• Do not use a hot air blower. If the air is too
hot, the bristles may melt.
9.2 Clean dust filter (FiRMHORN Avenue) 9.4 Align bristles