Starting the Generator (Electric Start-Gasoline)
1. Before starting the generator, check for loose
or missing parts and for any damage which
may have occurred during shipment.
2. Check oil level and fuel(Gasoline).
4. Turn the fuel selector switch to “
GAS
” position.
3. Make sure the LPG cylinder
knob is fully closed
.
When starting engine, pull cord slowly until resistance
is felt and then pull rapidly to avoid kickback.
Keep choke lever in “
START
” position for only 1
pull of the recoil starter. After first pull, move
choke lever to the “
RUN
” position for up to the
next 3 pulls of the recoil starter. Too much
choke leads to sparkplug fouling/engine
flooding due to the lack of incoming air. This
will cause the engine not to start.
NOTE:
When the fuel selector switch is turned
to the “
GAS”
position, the indicator light will
become
RED
up to
4 minutes
(before goes off).
Starting the engine successfully during these
4 minutes
will turn the indicator light
GREEN
.
5. Disconnect all electrical loads from the
generator. Never start or stop the generator
with electrical devices plugged in or turned on.
6. Move choke lever located on engine to “
START
”
position.
7. Flip the engine switch to the "
START
"(
l
) position
for few seconds and then release.
l
3
sec
.
REMINDER:
MUST HAVE
SOLID RED INDICATOR
LIGHT
TO BE ABLE TO START THE GENERATOR.
THE GENERATOR CANNOT BE STARTED DURING
BATTERY POWER SAVING MODE
UNLESS
THE FUEL SELECTOR SWITCH IS TURNED TO
THE “
OFF
” POSITION AND THEN TURNED
BACK TO THE “
GAS
” POSITION.
See
Indicator light
-
Battery power Saving
Mode
section for more information.
See
Indicator light
-
Battery power Saving
Mode
section for more information.
THE FUEL SELECTOR SWITCH IS TURNED TO THE “
OFF
”
POSITION AND THEN TURNED BACK TO THE “
LPG
”
POSITION.
WARNING
English
Page
20
Support: [email protected]