Firman ECO1500, Руководство пользователя

Страница: 22 / 48

9. TROUBLE SHOOTING
Page 21
Problem Cause Correction
Engine is running , but no
AC output is available .
1. Circuit breaker is open .
2. Fault in generator .
3. Poor connection or defective cord
set .
4. Connected device is bad .
1. Reset circuit breaker .
2. Contact authorized service facility .
3. Check and repair .
4. Connect another device that is in
good condition .
Engine runs good at
no - load but “ bogs down ”
when loads are connected .
1. Short circuit in a connected load .
2. Engine speed is too slow .
3. Generator is overloaded .
4. Shorted generator circuit .
1. Disconnect shorted electrical load .
2. Contact authorized service facility .
3. See Don't Overload Generator
4. Contact authorized service facility .
Engine will not start ; starts
and runs rough or shuts
down when running .
1. Engine switch set to OFF (0)
position .
2. Fuel shutoff lever is in OFF (0)
position .
3. Low oil level .
4. Dirty air cleaner .
5. Out of fuel .
6. Stale fuel .
7. Spark plug wire not connected to
spark plug .
8. Bad spark plug .
9. Water in fuel .
10. Flooded .
11. Excessively rich fuel mixture .
12. Intake valve stuck open or closed .
13. Engine has lost compression .
1. Set engine switch to ON ( I )
position .
2. Move fuel shutoff lever to ON ( I )
position .
3. Fill crankcase to proper level or
place generator on level surface .
4. Clean or replace air cleaner .
5. Fill fuel tank .
6. Drain fuel tank and carburetor ; fill
with fresh fuel .
7. Connect wire to spark plug .
8. Replace spark plug .
9. Drain gas tank and carburetor ; fill
with fresh fuel .
10. Wait 5 minutes and re - crank engine .
11. Contact authorized service facility .
12. Contact authorized service facility .
13. Contact authorized service facility .
Engine lacks power .
1. Load is too high .
2. Dirty air filter .
1. Don't Overload Generator
2. Replace air filter .
Engine “ hunts ” or falters . Carburetor is running too rich or too Contact authorized service facility .
lean .