SAM-A1 Owner’s Manual
FSL0132
Fireworks Solutions Limited (FSL) has proprietary rights in the information disclosed herein. The recipient, by accepting this document agrees that neither this document nor the
information disclosed herein nor any part(s) thereof shall be produced in any manner whatsoever or transferred to other documents or media or used or disclosed to any third party
for any purpose except as specifically authorised in writing by FSL. All rights reserved under the copyright laws.
FSL0132 Version 5.1 © 2020 Fireworks Solutions Limited Page 14
6.
Using the SAM-A1 amplifier
Once the amplifier has been connected as per section 4.2 and the valves are fitted as per section
5, your amplifier is ready to use!
Ensure the volume control is at minimum, see picture above and turn on the amplifier. Within 10
seconds you should see all the valves glowing orange (and if you look carefully – probably some
blue too – remember they get hot!).
Within about 20-30 seconds from switch on the amplifier will be starting to work (it can take up to
5 minutes to reach full specification).
Select your audio source (pre-amplifier) or press play etc. to start the music/audio source.
Turn the volume control up (clockwise) until the desired listening volume is achieved.
Volume
Minimum
Maximum
