Firetide HotPoint 1000S, Руководство по установке

Страница: 15 / 20

13
Restoring Default Settings
You can change or restore the default settings for your HotPoint router using the HotPoint Manager software. You can also use the following proce-
dure to restore the factory default settings without HotPoint Manager.
1. Connect an Ethernet crossover cable between ports labeled Ethernet 2 and Ethernet 3.
2. Plug in the HotPoint power adapter and wait for red “fault” LED to turn on and then off.
3. Unplug the HotPoint power adapter and disconnect the crossover cable. The default settings are now restored.
HotPoint Factory Default Settings
AES Encryption: Disabled
WEP Encryption: Disabled
Mesh IP address:
192.168.224.100
Ethernet ports: All ports enabled
HotPoint Manager username:
admin
HotPoint Manager password: admin
Troubleshooting
The best way to troubleshoot individual HotPoint routers and your entire Firetide mesh network is to use the HotPoint Manager software. With
HotPoint Manager you will be able to view mesh activity, customize your network confi gurations and change the default settings on your HotPoint
routers. This software is available at no charge from the Firetide web site. See page 8 for downloading and installation instructions.