P
AGE
14
OF
18
F
IRES
OF
T
RADITION
I
NSTALL
I
NSTRUCTIONS
FOR
J
URASTONE
T
ORRANCE
#4004
The installation of a Torrance mantel
with a Horizon firebox and Clearview
front requires the 3 piece slip kit
JSUR10. The side slips or legs of this kit
will need to be cut down in length to 29
3/4” [you will see a line indicating this
on the back of the slip]. This can be done
with a stone or tile saw. Do not cut lower
than this dimension!
It is very important that sufficient
screws are installed in the brackets and
in the wood to support the whole
mantel. Failure to insure that these
brackets are firmly secured to the wall
risks that the mantel could fall off the
wall, resulting in serious injury.
Carefully slide the hearth into
position, centering it on the fireplace
(you may find it easer to do this step if
you draw a very small center line on the
top back edge of the hearth). Put a
Note: The gloves are supplied for the
installers to insure a clean installation.
These help minimize the cleanup required
after the install is complete. Mix up a
small bit of the grout/cement by adding a
small amount of water until you get a
paste like consistency.
Butter the bottom of the hearth with a
thin bead of the cement provided, and
reset the hearth into position. Insure that
the hearth is level. A couple of wood
shims [not supplied for this purpose]
carefully positioned under the hearth can
help keep it level while the cement dries.
Step #6
Step #7
Step #8