Document NO.:RD-517E-39-001
Version: D 2017.04.28
- 6 -
Diagram 7
Wiring Instructions:
The appropriate power source is 220~240 volt AC single
phase supplied. When install or remove the smoke alarm
，
you must turn off the AC power to ensure safety.
Connecting wires are recommended to use a cross
sectional area from 0.8 mm
2
to 1.5 mm
2
, or according to
local wiring standard.
The smoke alarm device shall be provided with an
ALL-POLE MAINS SWITCH from a circuit within the
household consumer unit. The ALL-POLE MAINS
SWITCH shall have a contact separation of at least 3 mm
in each pole.
Should use the terminal to connect the AC QUICK
CONNECTOR and AC main power supply. The terminal
should allow the connection of conductors having
nominal cross-sectional areas of between 0.4mm
2
and 1.5
mm
2
. (refer to Diagram 9)
When alarms are interconnected, all interconnected units
must be powered from a single circuit.
A maximum of 12 Siterwell devices recommended may be
interconnected in a multiple station arrangement, over 12
devices maybe result in overload.
Diagram 8 illustrates interconnection wiring, inapposite
connection may result in damage to the alarm, failure to
operate, or a shock hazard.
Wire on alarm harness connected to:
Brown wire --- Live wire of AC line
Blue wire --- Neutral wire of AC line
White wire --- I/O signal as interconnect line of other
Units in the multiple station set up.
Mounting Instructions:
After selecting the proper location for your smoke alarm,
wiring the AC QUICK CONNECTOR harness as
described in the Wiring instructions (AC power should be
turned off at this stage).
Turn the alarm body counterclockwise and take off the
bracket.
Remove locking plug from the bracket with screwdriver
(refer to Diagram 9).
Hold the bracket on the installation position, mark
installation hole of the bracket with pencil.
Bore two installation holes on the sign with electric drill.
Make diameter of holes is 5mm, Strike the two plastic
plugs into holes with hammer.
Pull the AC QUICK CONNECTOR through the center
hole in the bracket. Attach the bracket to the plastic plugs
and fix tightly the screws into the plastic plugs. (Refer to
Diagram 10 - installation sketch map).
Fix the battery into battery box.
Connect the AC QUICK CONNECTOR to the alarm
body.
Fit the alarm on the bracket and turn the alarm body
clockwise, until matching well on the bracket.
Insert locking plug into the gap between bracket and
bottom cover for locking alarm in place (Refer to
Diagram 11).
Diagram 11
Live wire
Neutral wire
Signal wire
white
blue
brown
First
alarm
Additional
alarm
Additional
alarm
locking plug
Diagram 9
Diagram 8
