Document NO.:RD-517E-39-001
Version: D 2017.04.28
- 2 -
some circumstances where a household member may not
hear the alarm (i.e. outdoor or indoor noise, sound sleepers,
drug or alcohol usage, the hard of hearing, etc.). If you
suspect that this smoke alarm may not alert a household
member, install and maintain specialty smoke alarms.
Household member must hear the alarm’s warning sound
and quickly respond to it to reduce the risk of damage,
injury, or death that may result from fire, If a household
member is hard of hearing, install special smoke alarms
with lights or vibrating devices to alert occupants.
9. Smoke alarms can only sound their alarms when they
detect smoke or detect combustion particles in the air.
They do not sense heat, flame, or gas. This smoke alarm is
designed to give audible warning of a developing fire.
However, many fires are fast - burning, explosive, or
intentional, and others are caused by carelessness or safety
hazards. In this circs, Smoke may not remake the unit
alarm
QUICKLY ENOUGH
to ensure safe escape.
10. Smoke alarms have limitations. This smoke alarm is not
foolproof and is not warranted to protect lives or property
from fire. Smoke alarms are not a substitute for insurance.
Homeowners and renters should insure their lives and
property. In addition, it is possible for the smoke alarm to
fail at any time. For this reason, you must test the smoke
alarm weekly and replace unit after 10 years.
Battery Specification:
Voltage: DC 9V (Alkaline. Carbon Zinc, Lithium battery)
Gold Peak: GP1604S
；（
Carbon Zinc Battery
）
Gold Peak: GP1604A
；（
Alkaline Battery
）
Raymax :
6LR61
；
（
Alkaline Battery
）
EVE:
CR9V/P.
（
Lithium battery
）
Replace Battery:
1: Replace the battery:
1
Remove the locking plug between bracket and bottom
cover. (See Diagram 1)
Diagram 1
2
Remove the alarm body from the bracket.
3
Squeeze the locking arms on the sides of the AC Quick
connector while pulling the connector away from the
bottom of the alarm.
4
After alarm has been removed, you can open the battery
cover and replace with new battery. (See Diagram 2)
Diagram 2
Warning: AC power should be turned off at this stage.
2: After you replaced the battery:
1
Close the battery cover,
2
then plug the AC QUICK CONNECTOR into the back
of the alarm, making sure that the locks on the connector
snap into place.
3
Fit the alarm body on bracket and turn the alarm body
clockwise (See Diagram 3).
Diagram 3
4
Insert locking plug into the gap between bracket and
bottom cover (See Diagram 4).
Diagram 4
3: Turn on the AC power, in the meantime, the green LED
lights up. Then test smoke alarm using test button, the
sound pattern is 3 short beeps-pause 1.5 seconds, cycle
this pattern till release the test button.
Then unit will goes into hush mode of 8 minutes. During this
period, the RED LED will flash once every 8 seconds. It will
go to normal work status and flash once every 32 seconds
after 8 minutes. When you push the test button, if there’s no
sound output, it means that the smoke alarm is faulty or the
installing operation is wrong, and you can get helps from the
section: “trouble shooting”.
CAUTION:
Test the smoke alarm for correct operation
using the test facility whenever the battery is replaced.
WARNING: The AC power is danger. When you replace
battery, you must make sure the AC power is turned off.
Do Not Install Smoke Alarms in the
Following Places:
