P
AGE
32
M
AINTENANCE
Maintaining Your Fireplace's Appearance
!
Fingerprints or other marks left on the optional gold surface may become etched in place if they are
not wiped clean prior to turning the stove on. Clean the gold with denatured alcohol and a soft cloth.
¥
Use denatured alcohol and a soft cloth to clean gold surfaces (make sure the fireplace is cool). Other
cleaners may leave a film that may become etched into the gold.
Yearly Service Procedure
!
Failure to inspect and maintain the fireplace may lead to improper combustion and a potentially
dangerous situation. We recommend the following procedures be done by a qualified technician.
1
Check the pilot flame. It should engulf approximately 3/8" of the top of the thermopile and engulf
the top of the thermocouple (see illustration below). If it does not, contact your dealer for service.
2
Shut off gas to the fireplace by turning the gas control knob to "OFF" (see step A under "Starting the
Pilot" on page 29). Let the fireplace cool for 15 minutes. Remove the faceplate (see instructions
included with face) and glass (see page 24).
3
Remove the log set (
NOTE: the logs are very fragile -
see page 25). If any log is cracked or
deteriorated, replace it when re-installing. Check the logs for sooting. A small amount of soot along
the bottom of the logs is normal. If excessive sooting is found, the fireplace will require adjustment.
Contact your dealer.
4
Clean the burner pan (especially in the burner holes and slots) and inspect the following:
¥
Check for burner pan holes that are cracked, severely warped, or corroded.
¥
Make sure the burner pan assembly fits flat against the floor of the firebox.
¥
Check the firebox and area around the pilot to make sure there is no warping or damage.
If any problem is found, discontinue use and contact your dealer for service.
Check the burner
holes and slots.
Make sure the
burner pan seals
against the floor
of the firebox.
Check the walls and
ceiling of the firebox
for deterioration.
Burner Pan
Before Disassembly
: Check the pilot flame. It should
impinge the top 3/8Ó of the thermopile and engulf the
thermocouple.
3/8Ó
Thermopile
Pilot Hood
Thermocouple
5
Replace the log set. Replace the glass (if the glass is damaged, replace it). Make sure the gasket
along the perimeter of the glass contacts the face of the firebox and forms an air-tight seal. If it does
not, re-align or replace the gasket to insure an air-tight seal. Replace the faceplate.
6
Inspect the area behind the access door. Check the gas control valve and all of the gas lines. If any
damage is found, discontinue use and contact your dealer for service.
7
Start the pilot and turn on the main burner. The flames should be orange/yellow and not touch the
top of the firebox. If the pilot or main burners do not burn correctly, contact your dealer for service.
Monitor the blower operation.
8
Remove any debris or vegetation near the vent termination. Contact your dealer if any sooting or
deterioration is found near the vent termination.
Содержание 36DV-A/R
Страница 45: ...OPTIONAL EQUIPMENT CONTINUED PAGE 45...
