8
CI-2013-05-14
7. Installing the stove
1. Remove all outer packaging and carefully dispose.
2. Remove both front and rear top castings affixed to pallet and carefully set aside.
3. Carefully lift fire into approximate position on the floor protector.
4. Fit front and rear top castings on to fire box ensuring they fit snuggly down on the top rope seals.
5. Finally, accurately position fire ensuring all necessary safety clearances are adhered to along with the
correct alignment of the flue system to the spigot outlet.
6. Assemble and install flue system accordingly to comply with all national and local regulations.
7. Fit the air control knob - place the flat on the knob to the flat on the shaft situated on the right hand
side of the fire. Press home firmly.
8. Fit door knob with spacer as per drawing shown below.
9. Commission stove to ensure correct operation and adequate flue draw.
10. On completion of the installation and commissioning ensure that the operating instructions for the stove
are left with the customer. Ensure to advise the customer on the correct use of the appliance and warn
them to use only the recommended fuel for the stove.
